Buchumschlag

IMITATION MODEL OF A HIGH-SPEED INDUCTION MOTOR WITH FREQUENCY CONTROL

Purpose. To develop the imitation model of the frequency converter controlled high-speed induction motor with a squirrel-cage rotor in order to determine reasons causes electric motor vibrations and noises in starting modes. Methodology. We have applied the mathematical simulation of electromagnetic...

Ausführliche Beschreibung

Gespeichert in:

Bibliographische Detailangaben
Datum:	2017
Hauptverfasser:	Pliugin, V. E., Petrenko, A. N., Grinina, V., Grinin, O., Yehorov, A.
Format:	Artikel
Sprache:	Englisch
Veröffentlicht:	National Technical University "Kharkiv Polytechnic Institute" and Аnatolii Pidhornyi Institute of Power Machines and Systems of NAS of Ukraine 2017
Schlagworte:	induction motor squirrel cage high-speed scalar control ANSYS RMxprt Simplorer high-performance computing simulation vibration noise 621.313
Online Zugang:	http://eie.khpi.edu.ua/article/view/2074-272X.2017.6.02
Tags:	Tag hinzufügen Keine Tags, Fügen Sie den ersten Tag hinzu!
Назва журналу:	Electrical Engineering & Electromechanics

Institution

Electrical Engineering & Electromechanics

Ähnliche Einträge

Wavelet packet analysis for rotor bar breakage in an inverter induction motor
von: Abu Ibaid, O. Z. I., et al.
Veröffentlicht: (2023)

A METHOD FOR CALCULATING MECHANICAL CHARACTERISTICS OF INDUCTION MOTORS WITH SQUIRREL-CAGE ROTOR
von: Malyar, V. S., et al.
Veröffentlicht: (2019)

STATISTICAL OPTIMIZATION OF FREQUENCY REGULATED INDUCTION ELECTRIC DRIVES WITH SCALAR CONTROL
von: Shurub, Yu. V.
Veröffentlicht: (2017)

Wind farms integration into power system with improved location and stability problem solving
von: Hafaiedh, H., et al.
Veröffentlicht: (2025)

ENERGY-EFFICIENT DOUBLE CAGE INDUCTION MOTOR DESIGN AND SIMULATION FOR RENEWABLE-POWERED ELECTRIC VEHICLES
von: Patel, Dhavalkumar Kantilal, et al.
Veröffentlicht: (2025)

Impact of fractional filter in PI control loop applied to induction motor speed drive
von: Hassainia, S., et al.
Veröffentlicht: (2022)

CHALLENGES OF DYNAMIC SIMULATION OF HIGH-SPEED ELECTROMAGNETIC VALVES OF GAS DISTRIBUTION DEVICES
von: Baida, E. I., et al.
Veröffentlicht: (2020)

EXCITATION WITH A SERIES OF PULSES OF A LINEAR PULSE ELECTRODYNAMIC TYPE CONVERTER OPERATING IN POWER AND HIGH-SPEED MODES
von: Bolyukh, V. F., et al.
Veröffentlicht: (2020)

Harmonics suppression in high-speed railway via single-phase traction converter with an LCL filter using fuzzy logic control strategy
von: Aissaoui, M., et al.
Veröffentlicht: (2024)

Features of excitation of a linear electromechanical converter of induction type from an AC source
von: Bolyukh, V.F., et al.
Veröffentlicht: (2021)

Fractional-based iterative learning-optimal model predictive control of speed induction motor regulation for electric vehicles application
von: Nemouchi, B., et al.
Veröffentlicht: (2024)

PERFORMANCE ANALYSIS OF SIX-PHASE INDUCTION MACHINE-MULTILEVEL INVERTER WITH ARBITRARY DISPLACEMENT
von: Ben Slimene, Marwa
Veröffentlicht: (2020)

COMPARATIVE ANALYSIS OF TWO HIGH-SPEED SINGLE-PHASE ELECTRICAL MACHINES WITH PERMANENT MAGNETS ON THE STATOR
von: Prakht, V. A., et al.
Veröffentlicht: (2020)

Frequency experimental identification approach for single-phase induction motor common-mode parameters
von: Hakmi, Y., et al.
Veröffentlicht: (2024)

The nature of inclined seismic boundary in the Earth crust of the Scythian plate along the DOBRE-5 Profile
von: Farfuliak, L.
Veröffentlicht: (2015)

Experimental investigation of the 2D diffractive optical element for speckle reduction efficiency dependence on its speed and inclination angle
von: Prygun, A. V., et al.
Veröffentlicht: (2015)

COMPARISON OF ADJUSTABLE HIGH-PHASE ORDER INDUCTION MOTORS’ MERITS
von: Petrushin, V. S., et al.
Veröffentlicht: (2016)

STUDY OF FREQUENCY-CONTROLLED ASYNCHRONOUS MOTOR UNITS TEMPERATURE VERSUS LOAD AND POWER SUPPLY TYPE
von: Vakaruk, T. V., et al.
Veröffentlicht: (2014)

Development and study of a microprocessor automatic control system for a mono-switch tie type with a linear inductive electric motor and a discrete speed controller
von: Buriakovskyi, S. G., et al.
Veröffentlicht: (2022)

Комп’ютерне моделювання руху повітря по каналу насадки з використанням пакету Ansys Fluent
von: Кузьменко, Ігор Миколайович
Veröffentlicht: (2014)

КОМП’ЮТЕРНЕ МОДЕЛЮВАННЯ РУХУ РІДИНИ В СОПЛАХ ВЕНТУРІ РІЗНИХ КОНФІГУРАЦІЙ
von: Avdieieva, L., et al.
Veröffentlicht: (2022)

Performance evaluation and analysis by simulation for sliding mode control with speed regulation of permanent magnet synchronous motor drives in electric vehicles
von: Senani, F., et al.
Veröffentlicht: (2025)

INFLUENCE OF FERROMAGNETIC CORE PARAMETERS ON INDUCTION-TYPE DYNAMIC MOTOR EFFICIENCY
von: Bolyukh, V. F., et al.
Veröffentlicht: (2012)

A high-frequency modeling of AC motor in a frequency range from 40 Hz to 110 MHz
von: Miloudi, H., et al.
Veröffentlicht: (2022)

Vizualizing of MTS data by the method of scalar impedances for numerical models of elementary conducting structures
von: Prychepiy, T.I.
Veröffentlicht: (2014)

On a possibility of usage of the scalar impedances for solving the inverse MTS problem for three-dimensional models
von: Prichepiy, T. I.
Veröffentlicht: (2016)

Exact values of girth for some graphs \(D\left({k},{q}\right)\) and upper bounds of the order of cages
von: Pikuta, Piotr
Veröffentlicht: (2018)

ASSESSMENT OF THE POSSIBILITY OF USING WIND SPEED REANALYSIS DATA FOR WIND ENERGY CALCULATIONS
von: Petrenko, K., et al.
Veröffentlicht: (2023)

РОЗРАХУНОК ВОЛЬТ-АМПЕРНОЇ ХАРАКТЕРИСТИКИ ШУНТУВАЛЬНОГО РЕАКТОРА З ПРОМІЖКАМИ В СТРИЖНІ
von: Іванков, В.Ф., et al.
Veröffentlicht: (2015)

APPROXIMATE CALCULATION OF BASIC CHARACTERISTICS OF PLASMA AT THE AIR ELECTRIC EXPLOSION OF METAL CONDUCTOR
von: Baranov, M. I., et al.
Veröffentlicht: (2017)

RESEARCH OF THE MAGNETOELECTRIC LINEAR OSCILLATORY MOTOR CHARACTERISTICS DURING OPERATION ON ELASTOVISCOUS LOADING
von: Bondar, R. P.
Veröffentlicht: (2019)

Implementation of a new flux rotor based on model reference adaptive system for sensorless direct torque control modified for induction motor
von: Saifi, R.
Veröffentlicht: (2023)

ANALYSIS OF THE OPERATION PECULIARITIES OF THE SUPERCONDUCTING INDUCTIVE CURRENT LIMITER WITH ADDITIONAL SUPERCONDUCTING SCREEN
von: Dan'ko, V. G., et al.
Veröffentlicht: (2017)

Disinfectant treatment of liquids with high specific electrical conductivity by high-voltage nanosecond pulses with a subnanosecond front
von: Boiko, M. I., et al.
Veröffentlicht: (2025)

PROBLEMS IN TESTING DIGITAL PROTECTIVE RELAY FOR IMMUNITY TO INTENTIONAL DESTRUCTIVE ELECTROMAGNETIC IMPACTS. CONTINUATION OF THE THEME
von: Gurevich, Vladimir I.
Veröffentlicht: (2015)

POWER CHARACTERISTICS OF A VIBRATOR WITH A LINEAR NONSALIENT-POLE ARMATURE MOTOR DRIVE
von: Bondar, R. P.
Veröffentlicht: (2014)

MODELING OF DYNAMIC AND QUASISTATIC MODES OF THE WORK OF A WIND PUMP INSTALLATION WITH CONSIDERATION OF STOCHASTIC COMPOUND WIND SPEED
von: Verbovij, А., et al.
Veröffentlicht: (2018)

Results of Experimental–Numerical Modeling of Smoke Flow under Various Temperature Conditions
von: Kolesnyk, Vitalii, et al.
Veröffentlicht: (2026)

Realization of a stochastic two-parameter model of the longitudinal component of the wind speed for wind energy problems
von: Vasko, P., et al.
Veröffentlicht: (2017)

Improved speed sensorless control for induction motor drives using rotor flux angle estimation
von: Tran, C. D., et al.
Veröffentlicht: (2025)