INVESTIGATION OF LINEAR PULSE ELECTROMECHANICAL CONVERTER OF INDUCTION TYPE WITH DOUBLE ARMATURE INTENDED FOR DESTROYING INFORMATION ON SSD STORAGE DEVICE

• Дата: 2018
• Автори: Bolyukh, V. F., Kashanskij, Yu. V., Kocherga, A. I., Schukin, I. S.
• Формат: Стаття
• Мова: English; Ukrainian
• Опубліковано: National Technical University "Kharkiv Polytechnic Institute" and State Institution “Institute of Technical Problems of Magnetism of the National Academy of Sciences of Ukraine” 2018
• Теми: linear pulse electromechanical converter of induction type; double armature; electrodynamic processes; digital SSD storage device; experimental sample; 621.313; 536.2.24; 539.2; линейный импульсный электромеханический преобразователь индукционного типа; двойной якорь; электродинамические процессы; цифровой SSD накопитель; экспериментальный образец
• Онлайн доступ: http://eie.khpi.edu.ua/article/view/2074-272X.2018.5.03
• Назва журналу: Electrical Engineering & Electromechanics

Purpose. The goal of the paper is to determine the influence of the linear pulse electromechanical converter (LPEC) parameters with a double armature on its electrical, power and temperature indices and experimental verification of the proposed design for an information destruction device in a flat SSD storage device. Methodology. Using the mathematical model that takes into account interrelated electrical, magnetic, thermal and mechanical processes, the influence of geometric parameters on the electrodynamic characteristics and the indices of the induction type LPEC with a double armature spanning the inductor from opposite sides is investigated. Results. It is shown that the currents in the inductor and armature change in accordance with the oscillation-damping law practically in antiphase. The maximum value of the current density in the inductor is 215.8 A/mm2, and in each of the identical parts of the double armature it is 299.7 A/mm2. The maximum value of electrodynamic forces (EDF) acting in opposite directions on the front and rear of the double armature is 11.99 kN, and the value of the EDF pulse is 4.59 N∙s. Originality. It is established that with axial removal of the rear part of the armature from the inductor, the maximum current densities in the inductor decrease, in the front part of the armature increase, and in the rear part of the armature decrease. The maximum value and the pulse of the EDF between the armature parts decrease. With an increase in the number of turns in the inductor and a decrease in the thickness of the copper bus, all the basic indicators of the LPEC increase. With an increase in the number of turns of the inductor from 26 to 56, the maximum EDF value acting between the parts of the armature increases almost 3 times, and the magnitude of the EDF pulse is 3.3 times. With an increase in the width of the copper bus and the width of the inductor, the main indicators of the LPEC decrease. With an increase in the width of the inductor from 10 mm to 20 mm, the maximum EDF between the armature parts decreases by 1.3 times, and the value of the EDF pulse decreases by 1.2 times. Practical value. Based on the conducted studies, an induction-type LPEC model with a double armature was designed and tested experimentally, designed to destroy information located on a solid-state digital SSD storage device.