Mathematical modeling of rheostat-reactor start of wound-rotor induction motors
Introduction. Wound-rotor induction motors are less common compared squirrel-cage induction motors. However, they occupy a significant share among electric drives with difficult starting conditions. Their advantage is obtaining a high starting electromagnetic torque at lower values of starting curre...
Gespeichert in:
| Datum: | 2022 |
|---|---|
| Hauptverfasser: | Malyar, V. S., Hamola, O. Ye., Maday, V. S., Vasylchyshyn, I. I. |
| Format: | Artikel |
| Sprache: | Englisch Ukrainisch |
| Veröffentlicht: |
National Technical University "Kharkiv Polytechnic Institute" and Аnatolii Pidhornyi Institute of Power Machines and Systems of NAS of Ukraine
2022
|
| Schlagworte: | |
| Online Zugang: | http://eie.khpi.edu.ua/article/view/257781 |
| Tags: |
Tag hinzufügen
Keine Tags, Fügen Sie den ersten Tag hinzu!
|
| Назва журналу: | Electrical Engineering & Electromechanics |
Institution
Electrical Engineering & ElectromechanicsÄhnliche Einträge
Mathematical modelling of starting modes of induction motors with squirrel-cage rotor
von: Malyar, V. S., et al.
Veröffentlicht: (2021)
von: Malyar, V. S., et al.
Veröffentlicht: (2021)
MODELLING OF DYNAMIC MODES OF AN INDUCTION ELECTRIC DRIVE AT PERIODIC LOAD
von: Malyar, V. S., et al.
Veröffentlicht: (2020)
von: Malyar, V. S., et al.
Veröffentlicht: (2020)
A METHOD FOR CALCULATING MECHANICAL CHARACTERISTICS OF INDUCTION MOTORS WITH SQUIRREL-CAGE ROTOR
von: Malyar, V. S., et al.
Veröffentlicht: (2019)
von: Malyar, V. S., et al.
Veröffentlicht: (2019)
RESONANT PROCESSES IN STARTING MODES OF SYNCHRONOUS MOTORS WITH CAPACITORS IN THE EXCITATION WINDINGS CIRCUIT
von: Malyar, V. S., et al.
Veröffentlicht: (2017)
von: Malyar, V. S., et al.
Veröffentlicht: (2017)
ANALYSIS OF A THYRISTOR VOLTAGE CONVERTER FED INDUCTION MOTOR START
von: Petrushin, V. S., et al.
Veröffentlicht: (2012)
von: Petrushin, V. S., et al.
Veröffentlicht: (2012)
STUDYING THE EFFECT OF AN ADDITIONAL ACTIVE RESISTANCE IN THE FIELD WINDING CIRCUIT ON STARTING CHARACTERISTICS OF SALIENT-POLE SYNCHRONOUS MOTORS
von: Malyar, V. S., et al.
Veröffentlicht: (2018)
von: Malyar, V. S., et al.
Veröffentlicht: (2018)
A mathematical model of an induction motor with the stator and rotor unsymmetry
von: Chaban, V. Y., et al.
Veröffentlicht: (2012)
von: Chaban, V. Y., et al.
Veröffentlicht: (2012)
METHOD OF DETERMINING THE START TIME OF INDUCTION MOTORS IN THE CONTROL OF RESISTOR-THYRISTOR MODULES
von: Lobov, V. I., et al.
Veröffentlicht: (2015)
von: Lobov, V. I., et al.
Veröffentlicht: (2015)
Wavelet packet analysis for rotor bar breakage in an inverter induction motor
von: Abu Ibaid, O. Z. I., et al.
Veröffentlicht: (2023)
von: Abu Ibaid, O. Z. I., et al.
Veröffentlicht: (2023)
THE DIAGNOSTICS OF INDUCTION MOTORS ROTOR BAR BREAKS BASED ON THE ANALYSIS OF ELECTROMOTIVE FORCE IN THE STATOR WINDINGS
von: Zagirnyak, M. V., et al.
Veröffentlicht: (2014)
von: Zagirnyak, M. V., et al.
Veröffentlicht: (2014)
DYNAMIC REGIMES OF ASYNCHRONOUS MOTORS WITH CONCATENATED CAPACITORS
von: Malyar, V. S., et al.
Veröffentlicht: (2015)
von: Malyar, V. S., et al.
Veröffentlicht: (2015)
A MATHEMATICAL MODEL OF THE ELECTRICAL ENGINEERING COMPLEX FOR DRIVE OF MAIN CIRCULATION PUMPS OF NUCLEAR REACTOR VVER-1000 OF NUCLEAR POWER PLANTS
von: Vasyliv, K. M., et al.
Veröffentlicht: (2019)
von: Vasyliv, K. M., et al.
Veröffentlicht: (2019)
Simulation of asynchronous modes of synchronous motors with capacitors in the excitation circuit
von: Malyar, V. S., et al.
Veröffentlicht: (2012)
von: Malyar, V. S., et al.
Veröffentlicht: (2012)
Dynamic measurement of magnetic characteristics of switched reluctance motor
von: Fan, J., et al.
Veröffentlicht: (2023)
von: Fan, J., et al.
Veröffentlicht: (2023)
DIAGNOSTICS OF INDUCTION MOTOR ROTOR COMBINED DEFECTS WITH AN INDUCTION METHOD
von: Vaskovskyi, Yu. M., et al.
Veröffentlicht: (2013)
von: Vaskovskyi, Yu. M., et al.
Veröffentlicht: (2013)
INTENSITY SETTER FOR A DEVICE OF SMOOTH START OF SUBMERSIBLE PUMP ELECTRIC MOTOR
von: Lobov, V. I., et al.
Veröffentlicht: (2016)
von: Lobov, V. I., et al.
Veröffentlicht: (2016)
RESEARCH OF DYNAMIC PARAMETERS OF THE ELECTRIC DRIVE ON THE BASIS OF ROLLING ROTOR MOTOR
von: Kulinchenko, G. V., et al.
Veröffentlicht: (2016)
von: Kulinchenko, G. V., et al.
Veröffentlicht: (2016)
Electromechanical processes during the start of induction-type magnetic levitation
von: Bolyukh, V. F.
Veröffentlicht: (2025)
von: Bolyukh, V. F.
Veröffentlicht: (2025)
Numerical-field analysis of active and reactive winding parameters and mechanical characteristics of a squirrel-cage induction motor
von: Milykh, V. I.
Veröffentlicht: (2023)
von: Milykh, V. I.
Veröffentlicht: (2023)
Technical solutions to reduce losses in magnetic cores and material consumption of three-phase transformer and reactor equipment
von: Stavynskyi, A. A., et al.
Veröffentlicht: (2024)
von: Stavynskyi, A. A., et al.
Veröffentlicht: (2024)
COMPARISON OF ENERGY CONSUMPTION OF VARIOUS ELECTRICAL MOTORS OPERATING IN A PUMPING UNIT
von: Goman, V. V., et al.
Veröffentlicht: (2020)
von: Goman, V. V., et al.
Veröffentlicht: (2020)
Starting conditions for the development of geothermal energy in Ukraine
von: Shurchkova Yu.A.
Veröffentlicht: (2019)
von: Shurchkova Yu.A.
Veröffentlicht: (2019)
REACTIVE POWER COMPENSATION IN ASYNCHRONOUS ELECTRIC DRIVES.
von: Malyar, V. S., et al.
Veröffentlicht: (2013)
von: Malyar, V. S., et al.
Veröffentlicht: (2013)
Features of prolongation of the service life of high- and intermediate-pressure rotors of K-200-130 steam turbine of Luhansk TPP
von: Chernousenko O.Yu., et al.
Veröffentlicht: (2018)
von: Chernousenko O.Yu., et al.
Veröffentlicht: (2018)
Improved speed sensorless control for induction motor drives using rotor flux angle estimation
von: Tran, C. D., et al.
Veröffentlicht: (2025)
von: Tran, C. D., et al.
Veröffentlicht: (2025)
Additional power loss in a frequency-controlled induction motor due to voltage higher harmonics
von: Petrenko, A. N., et al.
Veröffentlicht: (2012)
von: Petrenko, A. N., et al.
Veröffentlicht: (2012)
INFLUENCE OF FERROMAGNETIC CORE PARAMETERS ON INDUCTION-TYPE DYNAMIC MOTOR EFFICIENCY
von: Bolyukh, V. F., et al.
Veröffentlicht: (2012)
von: Bolyukh, V. F., et al.
Veröffentlicht: (2012)
MECHANICAL CHARACTERISTICS OF THREE-PHASE INDUCTION MOTORS WITH SINGLE-PHASE POWER SUPPLY
von: Malyar, V. S., et al.
Veröffentlicht: (2016)
von: Malyar, V. S., et al.
Veröffentlicht: (2016)
Implementation of a new flux rotor based on model reference adaptive system for sensorless direct torque control modified for induction motor
von: Saifi, R.
Veröffentlicht: (2023)
von: Saifi, R.
Veröffentlicht: (2023)
ICRF plasmas for fusion reactor applications
von: Lyssoivan, A., et al.
Veröffentlicht: (2007)
von: Lyssoivan, A., et al.
Veröffentlicht: (2007)
Magnetic system of thermonuclear reactor "Elemag"
von: Lavrent'ev, O.A., et al.
Veröffentlicht: (2005)
von: Lavrent'ev, O.A., et al.
Veröffentlicht: (2005)
DEVELOPMENT OF A MATHEMATICAL MODEL FOR A FREQUENCY-CONTROLLED ASYNCHRONOUS MOTOR ROTOR TEMPERATURE FIELD ON THE BASIS OF DIFFERENTIAL EQUATIONS OF HEAT CONDUCTION
von: Ostashevskiy, N. A., et al.
Veröffentlicht: (2013)
von: Ostashevskiy, N. A., et al.
Veröffentlicht: (2013)
THE INFLUENCE OF AERODYNAMIC CHARACTERISTICS OF A BLADE PROFILE ON THE ENERGY CHARACTERISTICS OF A WINDOW ROTOR
von: Holovko, V., et al.
Veröffentlicht: (2019)
von: Holovko, V., et al.
Veröffentlicht: (2019)
К-325-23,5 Steam Turbine High-Pressure Rotor Thermal and Thermo-structural State during cold start-up
von: Бахмутская, Ю. О., et al.
Veröffentlicht: (2017)
von: Бахмутская, Ю. О., et al.
Veröffentlicht: (2017)
К-325-23,5 Steam Turbine High-Pressure Rotor Thermal and Thermo-structural State during cold start-up
von: Бахмутская, Ю. О., et al.
Veröffentlicht: (2017)
von: Бахмутская, Ю. О., et al.
Veröffentlicht: (2017)
ANALYSIS OF STATIC CHARACTERISTICS OF THE CENTRIFUGAL REGULATOR OF THE WIND ROTOR ROTOR WITH ANTI-FLUGE CONTROL
von: Golovko, V., et al.
Veröffentlicht: (2022)
von: Golovko, V., et al.
Veröffentlicht: (2022)
The prospect on the use of Be mirrors in a fusion reactor with Be first wall
von: Bardamid, A.F., et al.
Veröffentlicht: (2003)
von: Bardamid, A.F., et al.
Veröffentlicht: (2003)
Technological and operating features of the AR-1000 reactors Generation III+ and small modular reactors MR-160
von: Vashchenko, Volodymyr, et al.
Veröffentlicht: (2021)
von: Vashchenko, Volodymyr, et al.
Veröffentlicht: (2021)
A METHOD OF AUTOMATIC DETERMINATION OF THE NUMBER OF THE ELECTRICAL MOTORS SIMULTANEOUSLY WORKING IN GROUP
von: Voloshko, A. V., et al.
Veröffentlicht: (2016)
von: Voloshko, A. V., et al.
Veröffentlicht: (2016)
UNIFIED MODELS OF ELEMENTS OF POWER SUPPLY SYSTEMS BASED ON EQUATIONS IN PHASE COORDINATES
von: Vepryk, Yu. M., et al.
Veröffentlicht: (2015)
von: Vepryk, Yu. M., et al.
Veröffentlicht: (2015)
Ähnliche Einträge
-
Mathematical modelling of starting modes of induction motors with squirrel-cage rotor
von: Malyar, V. S., et al.
Veröffentlicht: (2021) -
MODELLING OF DYNAMIC MODES OF AN INDUCTION ELECTRIC DRIVE AT PERIODIC LOAD
von: Malyar, V. S., et al.
Veröffentlicht: (2020) -
A METHOD FOR CALCULATING MECHANICAL CHARACTERISTICS OF INDUCTION MOTORS WITH SQUIRREL-CAGE ROTOR
von: Malyar, V. S., et al.
Veröffentlicht: (2019) -
RESONANT PROCESSES IN STARTING MODES OF SYNCHRONOUS MOTORS WITH CAPACITORS IN THE EXCITATION WINDINGS CIRCUIT
von: Malyar, V. S., et al.
Veröffentlicht: (2017) -
ANALYSIS OF A THYRISTOR VOLTAGE CONVERTER FED INDUCTION MOTOR START
von: Petrushin, V. S., et al.
Veröffentlicht: (2012)