Automated mesh production for limiter Wendelstein-7X configuration
A tool for automated mesh production for 3D multifluid plasma transport code Findif is presented. Mesh points for the code lie on magnetic field lines, which, in general, form a complicated tangle. Open field lines that end on solid parts of the machine are the source of difficulties. These lines ar...
Збережено в:
| Дата: | 2017 |
|---|---|
| Автори: | , , |
| Формат: | Стаття |
| Мова: | English |
| Опубліковано: |
Національний науковий центр «Харківський фізико-технічний інститут» НАН України
2017
|
| Назва видання: | Вопросы атомной науки и техники |
| Теми: | |
| Онлайн доступ: | http://dspace.nbuv.gov.ua/handle/123456789/122117 |
| Теги: |
Додати тег
Немає тегів, Будьте першим, хто поставить тег для цього запису!
|
| Назва журналу: | Digital Library of Periodicals of National Academy of Sciences of Ukraine |
| Цитувати: | Automated mesh production for limiter Wendelstein-7X configuration / G. Pełka, W. Stępniewski, R. Zagórski // Вопросы атомной науки и техники. — 2017. — № 1. — С. 25-27. — Бібліогр.: 3 назв. — англ. |
Репозитарії
Digital Library of Periodicals of National Academy of Sciences of Ukraine| Резюме: | A tool for automated mesh production for 3D multifluid plasma transport code Findif is presented. Mesh points for the code lie on magnetic field lines, which, in general, form a complicated tangle. Open field lines that end on solid parts of the machine are the source of difficulties. These lines are usually short and thousands of them are needed. A tool that helps to pick lines for the mesh that is described in this paper is based on calculation the distances of lines already admitted to the mesh and candidate ones. The results of the code run for the limiter configuration (OP-1.1 experimental phase) of the Wendelstein-7X device are shown here. Reasonably even coverage of space by points is achieved. |
|---|