Analysis of Cutting Surface During Cutting of Electric Sheets
The contribution evaluates the influence of the size of the cutting gap on the quality of the cutting surface during the cutting process. Four types of electrical sheets were evaluated. Examined sheet types have the nominal thickness of 0.65 and 0.5 mm. Sheets differ in mechanical properties (yield...
Збережено в:
| Дата: | 2017 |
|---|---|
| Автори: | , , , |
| Формат: | Стаття |
| Мова: | English |
| Опубліковано: |
Інститут проблем міцності ім. Г.С. Писаренко НАН України
2017
|
| Назва видання: | Проблемы прочности |
| Теми: | |
| Онлайн доступ: | http://dspace.nbuv.gov.ua/handle/123456789/173696 |
| Теги: |
Додати тег
Немає тегів, Будьте першим, хто поставить тег для цього запису!
|
| Назва журналу: | Digital Library of Periodicals of National Academy of Sciences of Ukraine |
| Цитувати: | Analysis of Cutting Surface During Cutting of Electric Sheets / E. Spišák, L. Kaščák, J. Majerníková, M. Džupon // Проблемы прочности. — 2017. — № 4. — С. 135-142. — Бібліогр.: 8 назв. — англ. |
Репозитарії
Digital Library of Periodicals of National Academy of Sciences of Ukraine| Резюме: | The contribution evaluates the influence of the size of the cutting gap on the quality of the cutting surface during the cutting process. Four types of electrical sheets were evaluated. Examined sheet types have the nominal thickness of 0.65 and 0.5 mm. Sheets differ in mechanical properties (yield strength, ultimate tensile strength, and elongation). For the impact analysis, four values of the 0.02, 0.05, 0.1, and 0.2 mm cutting gap were used. |
|---|