On gas and hydraulic tightness of accelerating sections
A technique for calculating the required impenetrability of brazing linac accelerating sections cooled by water and for control of their hydraulic tightness based on the total helium leakage rate is given. Three types of cooling systems: a water stream in tubes soldered on the outer surface of the s...
Збережено в:
| Дата: | 2021 |
|---|---|
| Автор: | |
| Формат: | Стаття |
| Мова: | English |
| Опубліковано: |
Національний науковий центр «Харківський фізико-технічний інститут» НАН України
2021
|
| Назва видання: | Вопросы атомной науки и техники |
| Теми: | |
| Онлайн доступ: | http://dspace.nbuv.gov.ua/handle/123456789/195112 |
| Теги: |
Додати тег
Немає тегів, Будьте першим, хто поставить тег для цього запису!
|
| Назва журналу: | Digital Library of Periodicals of National Academy of Sciences of Ukraine |
| Цитувати: | On gas and hydraulic tightness of linac accelerating sections / V.F. Zhiglo // Problems of Atomic Science and Technology. — 2021. — № 3. — С. 142-145. — Бібліогр.: 9 назв. — англ. |
Репозитарії
Digital Library of Periodicals of National Academy of Sciences of Ukraine| Резюме: | A technique for calculating the required impenetrability of brazing linac accelerating sections cooled by water and for control of their hydraulic tightness based on the total helium leakage rate is given. Three types of cooling systems: a water stream in tubes soldered on the outer surface of the sections, a water stream along the outer surface and along the internal cooling channels in sections are considered. It is shown that the contact of accelerating sections surface with cooling water requires increasing the tightness of their soldering at least by 66 times. As an example, requirements for hydraulic and air tightness of accelerating sections for the developed accelerator LU-10 NSC KIPT are given. |
|---|