Method to Study the Creep of Complex-Shaped Functionally-Graded Bodies

• Видавець: Journal of Mechanical Engineering
• Дата: 2020
• Автор: Sklepus, Serhii M.
• Формат: Стаття
• Мова: English; Russian
• Опубліковано: Journal of Mechanical Engineering 2020
• Теми: функционально-градиентный материал; тело вращения; ползучесть; метод R-функций; УДК 539.3; functionally graded material; body of revolution; creep; R-functions method; UDC 539.3; функціонально-градієнтний матеріал; тіло обертання; повзучість; метод R-функцій
• Онлайн доступ: https://journals.uran.ua/jme/article/view/198998

The creep problem of complex-shaped functionally-graded bodies of revolution is considered. For the variational statement of the problem, the Lagrange functional is used, defined at kinematically possible displacement rates. A numerical-analytical method is developed for solving a non-linear initial-boundary creep problem. It is based on the combined use of the R-functions, Ritz and Runge-Kutta-Merson methods. The advantages of the proposed method include: exact consideration of the geometric information about the boundary-value problem at the analytical level, without any approximation thereof; representation of an approximate solution to the problem in an analytical form; exact satisfaction of boundary conditions; automatic time step selection. Solved are the problems of creep both for a hollow straight cylinder and a complex-shaped body of revolution (a cylinder with a rectangular cut-out on the outer surface), both cylinders being loaded with a constant inner pressure, made of the functionally graded material (FGM) based on SiC particle-reinforced aluminium. The creep of the material is described by Norton’ law. Both Young's modulus and creep characteristics of the material depend on the volume part of the reinforcing material. Both ends of the cylinder are free of external load, and are fixed in such a way that the radial displacements are equal to zero. A corresponding partial solution structure is constructed that satisfies the boundary conditions for displacement rates. The calculations were performed for cylinders of two different composite materials: a material with a uniform distribution of SiC particles and an FGM with a difference in the volume content of reinforcing particles along the radius, with the average volumetric content of reinforcing SiC particles in the two cases being the same. The influence of both the gradient properties of the material and geometric shape on the stress-strain state (SSS) under creep conditions was investigated. The presence of a rectangular cut-out on the outer surface of a cylinder in all cases leads to an increase in displacements and stresses. Moreover, the degree of influence of the geometric shape on the SSS during creep substantially depends on the gradient properties of the material. For a cut-out cylinder made of the material with a uniform distribution of SiC particles, there is a significant increase in displacements and stresses after 100 hours of creep compared with a straight cylinder. For bodies of revolution made of a functionally graded material, the cut-out effect on the SSS is less pronounced.