Buchumschlag

Enhancing the Efficiency of the Turbogenerator Cooling System Through the Use of Finned Tubes in the Gas Cooler

The reliability of a high-power turbogenerator largely depends on its cooling system. The trouble-free and efficient operation of this system, in particular the gas cooler, is a problem that has not been fully resolved as of now. A modernized design of a gas cooler for a 325 MW turbogenerat...

Ausführliche Beschreibung

Gespeichert in:

Bibliographische Detailangaben
Datum:	2026
1. Verfasser:	Шестак, Б. К.
Format:	Artikel
Sprache:	Englisch Ukrainisch
Veröffentlicht:	Інститут енергетичних машин і систем ім. А. М. Підгорного Національної академії наук України 2026
Online Zugang:	https://journals.uran.ua/jme/article/view/341496
Tags:	Tag hinzufügen Keine Tags, Fügen Sie den ersten Tag hinzu!
Назва журналу:	Journal of Mechanical Engineering

Institution

Journal of Mechanical Engineering

Ähnliche Einträge

Enhancing the Efficiency of the Turbogenerator Cooling System Through the Use of Finned Tubes in the Gas Cooler
von: Шестак, Б. К.
Veröffentlicht: (2026)

Mathematical modeling of heat exchanger with liquid flow for tube with polyzone finning
von: Максименко-Шейко, К. В., et al.
Veröffentlicht: (2018)

Mathematical modeling of heat exchanger with liquid flow for tube with polyzone finning
von: Максименко-Шейко, К. В., et al.
Veröffentlicht: (2018)

Thermal state of the rotor winding of the turbogenerator with direct hydrogen cooling
von: Кобзарь, К. А., et al.
Veröffentlicht: (2015)

Thermal state of the rotor winding of the turbogenerator with direct hydrogen cooling
von: Кобзарь, К. А., et al.
Veröffentlicht: (2015)

Development Thermal state of the rotor of the turbogenerator with direct hydrogen cooling
von: Овсянникова, Е. А.
Veröffentlicht: (2017)

Development Thermal state of the rotor of the turbogenerator with direct hydrogen cooling
von: Овсянникова, Е. А.
Veröffentlicht: (2017)

Thermomechanical loads of powerful turbogenerator stator winding insulation in the presence of water cooling defects
von: Kuchynskyi, K. A., et al.
Veröffentlicht: (2023)

Efficiency enhancement strategy implementation in hybrid electric vehicles using sliding mode control
von: Ibrar, A., et al.
Veröffentlicht: (2023)

Enhancing grid stability and low voltage ride through capability using type 2 fuzzy controlled dynamic voltage restorer
von: Sajan, Ch., et al.
Veröffentlicht: (2024)

Improvement of the operational Properties of sintered Copper steel through the use of an efficient alloying method
von: Pinchuk, S.Y., et al.
Veröffentlicht: (2020)

NUMERICAL FIELD ESTIMATION OF TURBOGENERATOR STATOR WINDING SHORTENING EFFICIENCY
von: Milykh, V. I., et al.
Veröffentlicht: (2014)

Enhancement of Aeroengine Combustion Chamber Air Cooling Holes Design for Emission Reduction and Pattern Factor Control
von: Hajivand, Masoud
Veröffentlicht: (2025)

Enhancement of Aeroengine Combustion Chamber Air Cooling Holes Design for Emission Reduction and Pattern Factor Control
von: Hajivand, Masoud
Veröffentlicht: (2025)

ENERGY EFFICIENCY OF THE SHALLOW AQUIFERS UTILIZATION FOR THE DISTRICT HEATING AND COOLING
von: Morozov, Yu., et al.
Veröffentlicht: (2019)

Improving the efficiency of radial-axial rotors of turbine stages through the use of complex lean of trailing edges
von: Rusanov, R. A., et al.
Veröffentlicht: (2016)

Improving the efficiency of radial-axial rotors of turbine stages through the use of complex lean of trailing edges
von: Rusanov, R. A., et al.
Veröffentlicht: (2016)

Enhancing power system security using soft computing and machine learning
von: Venkatesh, P., et al.
Veröffentlicht: (2023)

Energy efficiency of cooling systems of thermal stresses the most powerful turbo units with supercritical and supercritical steam parameters of the initial
von: Переверзев, Д. А., et al.
Veröffentlicht: (2016)

Energy efficiency of cooling systems of thermal stresses the most powerful turbo units with supercritical and supercritical steam parameters of the initial
von: Переверзев, Д. А., et al.
Veröffentlicht: (2016)

USE OF GEOTHERMAL COOLING BY AIR CONDITIONING SYSTEMS AS A MEANS OF REDUCING THE LOAD ON POWER SUPPLY SYSTEMS IN THE WARM SEASON
von: Lysak , O.
Veröffentlicht: (2025)

CW electron accelerator. Resonator cooling efficiency and thermal strain coupled analysis procedure
von: Zhelezov, S.A., et al.
Veröffentlicht: (2006)

Some questions of the system analysis of the efficiency of the compressor units with gas-turbine drive for the oil and gas industry
von: Прилипко, С. А., et al.
Veröffentlicht: (2012)

Some questions of the system analysis of the efficiency of the compressor units with gas-turbine drive for the oil and gas industry
von: Прилипко, С. А., et al.
Veröffentlicht: (2012)

Influence of eccentricity on heat transfer in borehole counterflow heat exchanger of tube-in-tube type
von: Бучко, А. В., et al.
Veröffentlicht: (2016)

Influence of eccentricity on heat transfer in borehole counterflow heat exchanger of tube-in-tube type
von: Бучко, А. В., et al.
Veröffentlicht: (2016)

Integrated through-silicon-via-based inductor design in buck converter for improved efficiency
von: Namoune, A., et al.
Veröffentlicht: (2023)

PECULIARITIES OF LITHOGENESIS AND OIL AND GAS PROSPECTS OF PALEOCENE DEPOSITS OF THE NORTHERN SLOPE OF THE KARKINITsky THROUGH
von: ГРИГОРЧУК, К.Г., et al.
Veröffentlicht: (2022)

Assessment of Factors Influencing Market Leadership and Innovation of FinTech Companies in the Digital economy
von: Anguelov, Kiril, et al.
Veröffentlicht: (2025)

Application package for computations of 3d flow of viscous gas through tur-bomachinery cascades
von: Ершов, С. В.
Veröffentlicht: (2012)

TECHNICAL AND ECONOMIC ASPECTS GREENHOUSE GAS EMISSION REDUCTION THROUGH THE DEVELOPMENT OF RENEWABLE ENERGY SOURCES
von: Khilko, V.
Veröffentlicht: (2019)

Application package for computations of 3d flow of viscous gas through tur-bomachinery cascades
von: Ершов, С. В.
Veröffentlicht: (2012)

COMPUTER MODELING ANALYSIS OF PHOTOVOLTAIC (PV) MODULES WITHOUT AND WITH INTEGRATED COOLING SYSTEMS
von: Axtamov , T. Z., et al.
Veröffentlicht: (2025)

Increasing the efficiency of cryogenic automobile power systems using thermoelectric generators
von: Traum, M. J., et al.
Veröffentlicht: (2016)

Increasing the efficiency of cryogenic automobile power systems using thermoelectric generators
von: Traum, M. J., et al.
Veröffentlicht: (2016)

Studying the efficiency of the electrode materials operation in the electrolysis systems providing a separate cycle of gas generation
von: Соловей, Виктор Васильевич, et al.
Veröffentlicht: (2015)

Studying the efficiency of the electrode materials operation in the electrolysis systems providing a separate cycle of gas generation
von: Соловей, Виктор Васильевич, et al.
Veröffentlicht: (2015)

Use of a Hydrogen Metal Hydride System to Increase Glass Production Efficiency
von: Chorna, Natalia A., et al.
Veröffentlicht: (2019)

Use of a Hydrogen Metal Hydride System to Increase Glass Production Efficiency
von: Chorna, Natalia A., et al.
Veröffentlicht: (2019)

INVESTIGATION OF RESERVES FOR ENHANCING THE ENERGY EFFICIENCY OF A SMALL HYDROPOWER PLANT UNDER VARIATIONS IN TURBINE GENERATOR CURRENT FREQUENCY
von: Popovych, O., et al.
Veröffentlicht: (2025)