On application of heat-conductive plastics in LED technology
A comparative analysis of the characteristics of heat-conducting plastic was performed. The results of the thermal measurements of two of the same type 3W LED modules installed on heat sink with the same area of heat-dissipating surface made of aluminum and heat-conducting polymer have been pr...
Збережено в:
| Опубліковано в: : | Semiconductor Physics Quantum Electronics & Optoelectronics |
|---|---|
| Дата: | 2013 |
| Автори: | , , |
| Формат: | Стаття |
| Мова: | Англійська |
| Опубліковано: |
Інститут фізики напівпровідників імені В.Є. Лашкарьова НАН України
2013
|
| Онлайн доступ: | https://nasplib.isofts.kiev.ua/handle/123456789/117692 |
| Теги: |
Додати тег
Немає тегів, Будьте першим, хто поставить тег для цього запису!
|
| Назва журналу: | Digital Library of Periodicals of National Academy of Sciences of Ukraine |
| Цитувати: | On application of heat-conductive plastics in LED technology / Yu.V. Trofimov, S.I. Lishik, P.P. Pershukevich // Semiconductor Physics Quantum Electronics & Optoelectronics. — 2013. — Т. 16, № 2. — С. 198-200. — Бібліогр.: 1 назв. — англ. |
Репозитарії
Digital Library of Periodicals of National Academy of Sciences of Ukraine| Резюме: | A comparative analysis of the characteristics of heat-conducting plastic was
performed. The results of the thermal measurements of two of the same type 3W LED
modules installed on heat sink with the same area of heat-dissipating surface made of
aluminum and heat-conducting polymer have been presented. It has been shown that the
overheating of LED module mounted on the heat-conducting polymer heat sink is
2…3 °С higher than that on the aluminum heat sink (thermal conductivity is 20 times
higher). The ranges of applicability of the heat-conducting plastics in LED technology
have been determined.
|
|---|---|
| ISSN: | 1560-8034 |