Creep-induced structural changes in Ni-Si-B amorphous alloy
The influence of the stress annealing on the reversible structural relaxation of a Ni-Si-B amorphous ribbon was studied. Creep-induced structural changes in the amorphous structure were derived from anisothermal DSC and dilatometric experiments. It is demonstrated that considerable enthalpy and spec...
Gespeichert in:
| Veröffentlicht in: | Проблемы прочности |
|---|---|
| Datum: | 2008 |
| ISSN: | 0556-171X |
| Hauptverfasser: | Jurikova, A., Miskuf, J., Csach, K., Ocelik, V. |
| Format: | Artikel |
| Sprache: | Englisch |
| Veröffentlicht: |
Інститут проблем міцності ім. Г.С. Писаренко НАН України
2008
|
| Schlagworte: | |
| Online Zugang: | https://nasplib.isofts.kiev.ua/handle/123456789/48414 |
| Tags: |
Tag hinzufügen
Keine Tags, Fügen Sie den ersten Tag hinzu!
|
| Назва журналу: | Digital Library of Periodicals of National Academy of Sciences of Ukraine |
| Zitieren: | Creep-induced structural changes in Ni-Si-B amorphous alloy / A. Jurikova, J. Miskuf, K. Csach, V. Ocelik // Проблемы прочности. — 2008. — № 1. — С. 24-27. — Бібліогр.: 11 назв. — англ. |
Institution
Digital Library of Periodicals of National Academy of Sciences of UkraineÄhnliche Einträge
Failure of Zr50 Ti16.5 Cu15 Ni18.5 amorphous metallic ribbon
von: Miskuf, J., et al.
Veröffentlicht: (2008)
von: Miskuf, J., et al.
Veröffentlicht: (2008)
Elastic properties of B19’ structure of NiTi alloy under uniaxial and hydrostatic loading from first principles
von: Sestak, P., et al.
Veröffentlicht: (2008)
von: Sestak, P., et al.
Veröffentlicht: (2008)
Constitutive Modeling for Al–Cu–Mg Alloy in Creep Aging Process
von: Yang, Y.L., et al.
Veröffentlicht: (2016)
von: Yang, Y.L., et al.
Veröffentlicht: (2016)
Комбинированная лазерно-микроплазменная наплавка порошками сплавов системы Ni–Cr–B–Si
von: Борисов, Ю.С., et al.
Veröffentlicht: (2012)
von: Борисов, Ю.С., et al.
Veröffentlicht: (2012)
Estimation of anisotropy of mechanical properties in Mg alloys by means of compressive creep tests
von: Dobes, F., et al.
Veröffentlicht: (2008)
von: Dobes, F., et al.
Veröffentlicht: (2008)
Constitutive description of creep behavior of Mg-4 Al-1Ca alloy
von: Milicka, K., et al.
Veröffentlicht: (2008)
von: Milicka, K., et al.
Veröffentlicht: (2008)
Theoretical-experimental model for predicting crack growth rate in structural alloys under combined action of fatigue and creep
von: Pokrovskii, V.V., et al.
Veröffentlicht: (2009)
von: Pokrovskii, V.V., et al.
Veröffentlicht: (2009)
The Sources and Affecting Factors of Creep Threshold Stress of Magnesium Based Composite
von: Tian, J.
Veröffentlicht: (2016)
von: Tian, J.
Veröffentlicht: (2016)
Microstructural features of failure surfaces and low-temperature mechanical properties of Ti-6Al-4V ELI ultra-fine grained alloy
von: Tabachnikova, E.D., et al.
Veröffentlicht: (2008)
von: Tabachnikova, E.D., et al.
Veröffentlicht: (2008)
Influence of Tantalum Addition on Microstructure and Mechanical Properties of the NiAl-Based Eutectic Alloy
von: Sheng, L.Y., et al.
Veröffentlicht: (2017)
von: Sheng, L.Y., et al.
Veröffentlicht: (2017)
Compressive creep of Fe3Al-type iron aluminide with Zr additions
von: Dobes, F., et al.
Veröffentlicht: (2008)
von: Dobes, F., et al.
Veröffentlicht: (2008)
Determining the Material and Physical Properties of Alloy La₀.₈₅Ce₀.₁₅Ni₅ Used in Hydrogen Storage
von: Jasminská, N., et al.
Veröffentlicht: (2017)
von: Jasminská, N., et al.
Veröffentlicht: (2017)
Isothermal Fatigue and Creep-Fatigue Interaction Behavior of Nickel-Base Directionally Solidified Superalloy
von: Haq, A.U., et al.
Veröffentlicht: (2018)
von: Haq, A.U., et al.
Veröffentlicht: (2018)
Strain-Induced Precipitation Kinetics of Vanadium Carbonitride Precipitates with the Cubic Structure in High-Strength Weathering Steels
von: Cheng, J., et al.
Veröffentlicht: (2018)
von: Cheng, J., et al.
Veröffentlicht: (2018)
Study on the Fabrication of Nano-SiC/Ni-P Composite Coatings with the Assistance of Electromagnetic-Ultrasonic Compound Field
von: Zhou, H.Z., et al.
Veröffentlicht: (2017)
von: Zhou, H.Z., et al.
Veröffentlicht: (2017)
Сварные соединения аустенитной стали 25Cr-20Ni-2Si в форсированных турбопоршневых двигателях
von: Пинчук, Н.И., et al.
Veröffentlicht: (2002)
von: Пинчук, Н.И., et al.
Veröffentlicht: (2002)
Creep Failure Time of Thin-Walled Pipes under Combined Internal Pressure, Bending, and Tension
von: El Megharbel, A.
Veröffentlicht: (2010)
von: El Megharbel, A.
Veröffentlicht: (2010)
Tensile properties of a Fe-32Mn-6Si shape memory alloy
von: Bouraoui, T., et al.
Veröffentlicht: (2008)
von: Bouraoui, T., et al.
Veröffentlicht: (2008)
Microstructure and Wear Properties of the Quasi-Rapidly Solidified NiAl/ Cr(Mo,Dy) Hypoeutectic Alloy
von: Sheng, L.Y.
Veröffentlicht: (2016)
von: Sheng, L.Y.
Veröffentlicht: (2016)
Effect of the SiC Particle Orientation Anisotropy on the Tensile Properties of a Spray-Formed SiCp/Al-Si Composite
von: Li, W., et al.
Veröffentlicht: (2014)
von: Li, W., et al.
Veröffentlicht: (2014)
Optimization of the Microstructure and Mechanical Properties of a Laves Phase-Strengthened Hypoeutectic NiAl/Cr(Mo,W) Alloy by Suction Casting
von: Sheng, L.Y., et al.
Veröffentlicht: (2018)
von: Sheng, L.Y., et al.
Veröffentlicht: (2018)
Accelerating Effects of Cyclic Creep Due to the Alternative Load Compared with Constant Load for CD 304L
von: Daei-Sorkhabi, A.H., et al.
Veröffentlicht: (2015)
von: Daei-Sorkhabi, A.H., et al.
Veröffentlicht: (2015)
Experimental Investigation on Microstructure and Mechanical Properties of Direct Squeeze Cast Al–13%Si Alloy
von: Souissi, S., et al.
Veröffentlicht: (2012)
von: Souissi, S., et al.
Veröffentlicht: (2012)
Creep Lifetime Assessment of Pressure-Tight PE100 Pipes Based on a Slow Fatigue Crack Growth
von: Luo, W.B., et al.
Veröffentlicht: (2018)
von: Luo, W.B., et al.
Veröffentlicht: (2018)
Analysis of Residual Stresses during Heat Treatment of Large Forged Shafts Considering Transformation Plasticity and Creep Deformation
von: Yanagisawa, Y., et al.
Veröffentlicht: (2017)
von: Yanagisawa, Y., et al.
Veröffentlicht: (2017)
Relation between Mechanical Properties and Microstructure of Cast Aluminum Alloy AlSi9Cu3
von: Panuskova, M., et al.
Veröffentlicht: (2008)
von: Panuskova, M., et al.
Veröffentlicht: (2008)
Вторичное твердение наплавленного металла типа дисперсионно-твердеющей стали системы легирования Fe-C-Ni-Cr-Si-AI-Cu
von: Рябцев, И.А., et al.
Veröffentlicht: (2004)
von: Рябцев, И.А., et al.
Veröffentlicht: (2004)
Study of Mechanical Degradation of 9Cr-1Mo-V-Nb Steel under Creep-Fatigue Interaction Conditions
von: Kim, C.S.
Veröffentlicht: (2017)
von: Kim, C.S.
Veröffentlicht: (2017)
Correlation dependences between short-term/long-term static strength characteristics and creep resistance of tungsten at high temperatures
von: Borisenko, V.A., et al.
Veröffentlicht: (2005)
von: Borisenko, V.A., et al.
Veröffentlicht: (2005)
Creep-Fatigue Behavior Evaluation by Reversible Permeability of CrMo Ferritic Steel for Ultra-Supercritical Steem Power Plants
von: Kim, C.S.
Veröffentlicht: (2016)
von: Kim, C.S.
Veröffentlicht: (2016)
Effect of Si and Mn on Microstructure and Mechanical Properties of Vacuum Suction Casting Al–4.5Cu Alloy
von: He, T., et al.
Veröffentlicht: (2018)
von: He, T., et al.
Veröffentlicht: (2018)
Duplex surface treatment of stainless steel X12CrNi 18 8
von: Kadlec, J., et al.
Veröffentlicht: (2008)
von: Kadlec, J., et al.
Veröffentlicht: (2008)
High-Cycle Fatigue Properties and Damage Mechanism of Q345B Structural Steel
von: Hu, X.L., et al.
Veröffentlicht: (2017)
von: Hu, X.L., et al.
Veröffentlicht: (2017)
Effect of Preliminary Torsional Strain on Low-Cycle Fatigue of Q345B Structural Steel
von: Hu, X.L., et al.
Veröffentlicht: (2019)
von: Hu, X.L., et al.
Veröffentlicht: (2019)
Experimental and Numerical Analysis of Springback Behavior of Aluminum Alloys
von: Slota, J., et al.
Veröffentlicht: (2017)
von: Slota, J., et al.
Veröffentlicht: (2017)
Advanced Material Models for Stamping of AW 5754 Aluminum Alloy
von: Slota, J., et al.
Veröffentlicht: (2016)
von: Slota, J., et al.
Veröffentlicht: (2016)
Contact Deformation Behavior of an Elastic Silicone/SiC Abrasive in Grinding and Polishing
von: Li, N., et al.
Veröffentlicht: (2018)
von: Li, N., et al.
Veröffentlicht: (2018)
Mechanical Properties of Friction Stir-Welded Joints of Aluminum Alloys
von: Chen, W.J., et al.
Veröffentlicht: (2015)
von: Chen, W.J., et al.
Veröffentlicht: (2015)
Radiation-Induced Embrittlement of WWER-440 Reactor Pressure Vessel Steel under Loading
von: Grinik, E.U., et al.
Veröffentlicht: (2003)
von: Grinik, E.U., et al.
Veröffentlicht: (2003)
Application of volumetric method to the assessment of damage induced by action of foreign object on gas pipes
von: Adib, R., et al.
Veröffentlicht: (2006)
von: Adib, R., et al.
Veröffentlicht: (2006)
Ähnliche Einträge
-
Failure of Zr50 Ti16.5 Cu15 Ni18.5 amorphous metallic ribbon
von: Miskuf, J., et al.
Veröffentlicht: (2008) -
Elastic properties of B19’ structure of NiTi alloy under uniaxial and hydrostatic loading from first principles
von: Sestak, P., et al.
Veröffentlicht: (2008) -
Constitutive Modeling for Al–Cu–Mg Alloy in Creep Aging Process
von: Yang, Y.L., et al.
Veröffentlicht: (2016) -
Комбинированная лазерно-микроплазменная наплавка порошками сплавов системы Ni–Cr–B–Si
von: Борисов, Ю.С., et al.
Veröffentlicht: (2012) -
Estimation of anisotropy of mechanical properties in Mg alloys by means of compressive creep tests
von: Dobes, F., et al.
Veröffentlicht: (2008)