Buchumschlag

Measurement of a torque at the Kaplan turbine model runner blade using wireless telemetry

An advanced variant of an experimental method of investigating the blades torque using models of the Kaplan turbine runner was suggested. The investigation is based on using modern miniature electronics devices and wireless technologies. The experience of implementing the method suggested on the hyd...

Ausführliche Beschreibung

Gespeichert in:

Bibliographische Detailangaben
Datum:	2014
Hauptverfasser:	Веремеенко, И. С., Гладышев, C. В., Андрющенко, С. А., Агибалов, Е. С.
Format:	Artikel
Sprache:	Russisch
Veröffentlicht:	Інститут енергетичних машин і систем ім. А. М. Підгорного Національної академії наук України 2014
Schlagworte:	runner model Kaplan turbine blade torque strain gauge transducer experiment УДК621.224.
Online Zugang:	https://journals.uran.ua/jme/article/view/27165
Tags:	Tag hinzufügen Keine Tags, Fügen Sie den ersten Tag hinzu!
Назва журналу:	Energy Technologies & Resource Saving

Institution

Energy Technologies & Resource Saving

Ähnliche Einträge

Measurement of a torque at the Kaplan turbine model runner blade using wireless telemetry
von: Веремеенко, И. С., et al.
Veröffentlicht: (2014)

Computational and experimental investigations of the dynamic characteristics of the blades of the model kaplan turbine
von: Рябов, А. В., et al.
Veröffentlicht: (2014)

Computational and experimental investigations of the dynamic characteristics of the blades of the model kaplan turbine
von: Рябов, А. В., et al.
Veröffentlicht: (2014)

Installation for researches of assemblies of microhydroelectric power station
von: Дедков, В. Н., et al.
Veröffentlicht: (2012)

Installation for researches of assemblies of microhydroelectric power station
von: Дедков, В. Н., et al.
Veröffentlicht: (2012)

EFFECT OF GEOMETRICAL PARAMETERS OF PUMP-TURBINE RUNNERS ON ENERGY CHARACTERISTICS
von: Khoryev , O., et al.
Veröffentlicht: (2025)

Up-to-date level and main trends in development of hydraulic turbine construction in Ukraine
von: Линник, А. В., et al.
Veröffentlicht: (2016)

Numerical investigation of the three-dimensional viscous incompressible flow at the axial turbine draft tube
von: Русанов, А. В., et al.
Veröffentlicht: (2016)

Serial pump application as hydroturbine in low energetic
von: Дедков, В. Н.
Veröffentlicht: (2016)

Numerical investigation of the three-dimensional viscous incompressible flow at the axial turbine draft tube
von: Русанов, А. В., et al.
Veröffentlicht: (2016)

Serial pump application as hydroturbine in low energetic
von: Дедков, В. Н.
Veröffentlicht: (2016)

Up-to-date level and main trends in development of hydraulic turbine construction in Ukraine
von: Линник, А. В., et al.
Veröffentlicht: (2016)

Computational and experimental investigations of flow parts PL20 for rehabilitation of hydraulic turbines of kremenchug hydro power plant
von: Линник, А. В., et al.
Veröffentlicht: (2016)

Computational and experimental investigations of flow parts PL20 for rehabilitation of hydraulic turbines of kremenchug hydro power plant
von: Линник, А. В., et al.
Veröffentlicht: (2016)

Test rig of OJSC «Turboatom» for physical simulation of hydrodynamic process in water passages of model Kaplan hydroturbines
von: Линник, А. В., et al.
Veröffentlicht: (2014)

Test rig of OJSC «Turboatom» for physical simulation of hydrodynamic process in water passages of model Kaplan hydroturbines
von: Линник, А. В., et al.
Veröffentlicht: (2014)

Creation of Optimal Design of Runner Oil System of Kaplan Hydro-Turbines
von: Субботин, В. Г., et al.
Veröffentlicht: (2021)

Creation of Optimal Design of Runner Oil System of Kaplan Hydro-Turbines
von: Субботин, В. Г., et al.
Veröffentlicht: (2021)

Analysis of Stress-Strain State and Contact Pressures on Surfaces of Kaplan Runner Blade Bearing Bronze Bushes
von: Субботин, В. Г., et al.
Veröffentlicht: (2021)

Analysis of Stress-Strain State and Contact Pressures on Surfaces of Kaplan Runner Blade Bearing Bronze Bushes
von: Субботин, В. Г., et al.
Veröffentlicht: (2021)

PROSPECTS FOR THE USE OF LIMITED-ANGLE TORQUE MOTORS IN RENEWABLE ENERGY SYSTEMS
von: Chumak , V., et al.
Veröffentlicht: (2025)

Improve of the direct torque control strategy applied to a multi-phase interior permanent magnet synchronous motor using a super twisting sliding mode algorithm
von: Mehedi, F., et al.
Veröffentlicht: (2025)

Reduction of cogging torque of radial flux permanent magnet brushless DC motor by magnet shifting technique
von: Panchal, T. H., et al.
Veröffentlicht: (2022)

Implementation of a new flux rotor based on model reference adaptive system for sensorless direct torque control modified for induction motor
von: Saifi, R.
Veröffentlicht: (2023)

Field programmable gate array hardware in the loop validation of fuzzy direct torque control for induction machine drive
von: Aib, A., et al.
Veröffentlicht: (2023)

Direct torque control based on second order sliding mode controller for three-level inverter-fed permanent magnet synchronous motor: comparative study
von: Guezi, A., et al.
Veröffentlicht: (2022)

Performance enhancement of direct torque control induction motor drive using space vector modulation strategy
von: Moussaoui, L.
Veröffentlicht: (2022)

Experimental Strength Analysis of Variable Stiffness Waffel-Grid Cylindrical Compartments. Part 1. Experimental Procedure
von: Degtyarev, M. A., et al.
Veröffentlicht: (2019)

Experimental Strength Analysis of Variable Stiffness Waffel-Grid Cylindrical Compartments. Part 1. Experimental Procedure
von: Degtyarev, M. A., et al.
Veröffentlicht: (2019)

Slot opening displacement technique for cogging torque reduction of axial flux brushless DC motor for electric two-wheeler application
von: Patel, A. N.
Veröffentlicht: (2023)

Frequency analysis of stator currents of an induction motor controlled by direct torque control associated with a fuzzy flux estimator
von: Mabrouk, Y. A., et al.
Veröffentlicht: (2023)

Optimization of cogging torque in interior permanent magnet synchronous motor using optimum magnet v-angle
von: Patel, A. N., et al.
Veröffentlicht: (2023)

A dinamic method for risks evaluation in the financial management system
von: Kuznietsova, N. V.
Veröffentlicht: (2019)

Performance improvement of parallel dual-star permanent magnet synchronous machines via type-2 fuzzy direct torque control with a single six-phase inverter
von: Bounab, A., et al.
Veröffentlicht: (2026)

Experimental Study of the Effects of a Constant and Variable Electric Fields on the Strength Properties of the Blade Steel Surface Layer
von: Nechaev, A. V.
Veröffentlicht: (2019)

Experimental Study of the Effects of a Constant and Variable Electric Fields on the Strength Properties of the Blade Steel Surface Layer
von: Nechaev, A. V.
Veröffentlicht: (2019)

Study of the piezoelectric sensor KD-35 properties on the calibration device by the method of external pulse and on a real Earth track
von: Shcherbina, S.V., et al.
Veröffentlicht: (2016)

Selection of System Characteristic of Turbo-Compressor Package Based on Efficiency Analysis according to Full-Scale Test Results. P. III. Efficiency Research of Basic Systems of Turbo-Compressor Package GPA-C-6,3A/56-1,45 on Full-Scale Test Results
von: Щербаков, Н. С., et al.
Veröffentlicht: (2017)

Selection of System Characteristic of Turbo-Compressor Package Based on Efficiency Analysis according to Full-Scale Test Results. P. III. Efficiency Research of Basic Systems of Turbo-Compressor Package GPA-C-6,3A/56-1,45 on Full-Scale Test Results
von: Щербаков, Н. С., et al.
Veröffentlicht: (2017)

Vibration features of titanium alloy blades with erosive damages
von: Vorobiov, Yu. S., et al.
Veröffentlicht: (2019)