ФОРМУВАННЯ МОМЕНТУ АСИНХРОНОГО ДВИГУНА ПІД ЧАС РУШАННЯ
It is known that when starting some technological mechanisms, the resistance moment can exceed the passport value by several times. The article shows the possibility of forming the maximum possible starting torque with a minimum value of the stator current, proposes the technique for determining par...
Збережено в:
| Дата: | 2020 |
|---|---|
| Автор: | |
| Формат: | Стаття |
| Мова: | English |
| Опубліковано: |
Інститут електродинаміки НАН України, Київ
2020
|
| Теми: | |
| Онлайн доступ: | https://techned.org.ua/index.php/techned/article/view/347 |
| Теги: |
Додати тег
Немає тегів, Будьте першим, хто поставить тег для цього запису!
|
| Назва журналу: | Technical Electrodynamics |
Репозитарії
Technical Electrodynamics| Резюме: | It is known that when starting some technological mechanisms, the resistance moment can exceed the passport value by several times. The article shows the possibility of forming the maximum possible starting torque with a minimum value of the stator current, proposes the technique for determining parameters of the supply network when creating the maximum possible starting torque for an induction motor. The technique is the following sequence. The magnetization curve and its mathematical image (in the form of a polynomial) are determined for a more precise determination of machine parameters from experimental or passport data. Adequate values of influence factors (voltage and frequency) are determined to create a regression model on the dynamic mathematical model of an induction motor using an iterative method, changing the range and ratio of network parameters. The mathematical calculation of the regression model is performed with obtaining polynomial dependencies for Mn (U, f) and In (U, f) based on a given optimization criterion. The range of variation of U, f is determined from the polynomial Mn (U, f). Equating to the necessary value of the starting torque, from the passport data the author calculates the maximum permissible magnetic flux, with the mathematical dependence Ф = F (Iμ) and determines the value of U and f1 in the saturation region of the engine. The obtained values of the amplitude U and the frequency of the supply voltage f1 meet the optimization criterion In → min. Based on the obtained values of U and f1, the author forms a control signal of a frequency-controlled induction motor to create the necessary starting torque. References 10, table 1. |
|---|