Buchumschlag

MATHEMATICAL MODEL OF THE EMC DISCHARGE PROCESS SOLUTION IN ALONE STATE WIND TURBINE WITH ELECTRODYNAMIC PUMP DRIVER

Нерівномірність та випадковість надходження енергії від відновлюваних джерел енергії спонукає до розробки електроімпульсних установок для її використання.  Одною з причин, що стримують використання таких установок є відсутність відповідних математичних моделей, що не дає можливості здійснит...

Ausführliche Beschreibung

Gespeichert in:

Bibliographische Detailangaben
Datum:	2019
Hauptverfasser:	Holovko, V., Kokhanievych, V., Shykhailov, M., Donets, A., Percova, I.
Format:	Artikel
Sprache:	Ukrainisch
Veröffentlicht:	Institute of Renewable Energy National Academy of Sciences of Ukraine 2019
Schlagworte:	autonomous wind power installation capacitive drive electric-pulse unit electrodynamic drive discharge capacitance drive.
Online Zugang:	https://ve.org.ua/index.php/journal/article/view/201
Tags:	Tag hinzufügen Keine Tags, Fügen Sie den ersten Tag hinzu!
Назва журналу:	Vidnovluvana energetika

Institution

Vidnovluvana energetika

Ähnliche Einträge

IMMEDIATIVE MODEL OF THE CHARGING PROCESS OF THE EMCSENTIAL AC-CUMULATOR OF THE ELECTRODYNAMIC DRIVER PUMP IN ALONE STATE WINDTURBINE
von: Holovko, V., et al.
Veröffentlicht: (2019)

Substantiation of Boundary Accelerations of Roller Forming Unit Optimal Reversal Mode According to Forth-Order Acceleration
von: Loveykin, V. S., et al.
Veröffentlicht: (2019)

Substantiation of Boundary Accelerations of Roller Forming Unit Optimal Reversal Mode According to Forth-Order Acceleration
von: Loveykin, V. S., et al.
Veröffentlicht: (2019)

Influence of electroblasting breaker parameters on electric spark discharge characteristics in a circuit with an inductive-capacitive energy store
von: Dubovenko, K. V.
Veröffentlicht: (2012)

Traction electric drive based on fuel cell batteries and on-board inertial energy storage for multi unit train
von: Omelyanenko, V. I., et al.
Veröffentlicht: (2021)

Roller Forming Unit Dynamic Analysis with Energy Balanced Drive Dissipative Properties Taken into Account
von: Loveikin, V. S., et al.
Veröffentlicht: (2018)

Roller Forming Unit Dynamic Analysis with Energy Balanced Drive Dissipative Properties Taken into Account
von: Loveikin, V. S., et al.
Veröffentlicht: (2018)

Expansion of cylindrical tubular workpieces on high-voltage magnetic-pulse installation with controlled vacuum discharger
von: Ljutenko, L. A., et al.
Veröffentlicht: (2021)

BRUSHLESS VALVE ELECTRIC DRIVE WITH MINIMUM EQUIPMENT EXCESS FOR AUTONOMOUS FLOATING VEHICLE
von: Volyanskaya, Ya. B., et al.
Veröffentlicht: (2017)

POWER CHARACTERISTICS OF A VIBRATOR WITH A LINEAR NONSALIENT-POLE ARMATURE MOTOR DRIVE
von: Bondar, R. P.
Veröffentlicht: (2014)

STABILIZATION OF PARAMETERS OF ASYNCHRONOUS ELECTRIC DRIVE WITH VECTOR CONTROL
von: Khlopenko, N. J., et al.
Veröffentlicht: (2015)

Analysis of suitable converter for the implementation of drive system in solar photovoltaic panels
von: Themozhi, G., et al.
Veröffentlicht: (2024)

Investigation of a three-phase-single-phase induction electric drive under stochastic loads
von: Shurub, Yu. V.
Veröffentlicht: (2014)

Improvement of technical processes for producing cast rotor parts to increase performance characteristics of traction elecric drive
von: Акімов, Олег Вікторович
Veröffentlicht: (2014)

Improvement of technical processes for producing cast rotor parts to increase performance characteristics of traction elecric drive
von: Акімов, Олег Вікторович
Veröffentlicht: (2014)

APPLICATION OF VYSHNEGRADKY'S DIAGRAMS FOR TRANSIENT ANALYSIS IN ELECTRIC DISCHARGE INSTALLATIONS WITH STOCHASTIC LOAD
von: Suprunovska, N. I., et al.
Veröffentlicht: (2018)

Computer simulation of operation plant effective modes for water disinfection by electrical discharges in gas bubbles
von: Boiko, M. I., et al.
Veröffentlicht: (2024)

CAST-FILM POLYMER COMPOSITION DOSING SYSTEM DRIVE CONTROL
von: Kulinchenko, G. V., et al.
Veröffentlicht: (2014)

SIMULATION OF A HIGH-POWERED VARIABLE FREQUENCY AC DRIVE BASED ON A MULTIPULSE CURRENT SOURCE INVERTER
von: Zhemerov, George G., et al.
Veröffentlicht: (2013)

Mathematical modelling of transients in the electric drive of the turnout of the mono-sleeper type with switched-inductor motor
von: Buriakovskyi, S. G., et al.
Veröffentlicht: (2021)

Analysis of the strategies for managing extended-range electric vehicle powertrain in the urban driving cycle
von: Lasocki, J., et al.
Veröffentlicht: (2022)

Research for an enhanced fault-tolerant solution against the current sensor fault types in induction motor drives
von: Tran, C. D., et al.
Veröffentlicht: (2024)

PROSPECTS FOR THE USE OF LIMITED-ANGLE TORQUE MOTORS IN RENEWABLE ENERGY SYSTEMS
von: Chumak , V., et al.
Veröffentlicht: (2025)

DEVELOPMENT TRENDS FOR ROLLING STOCK TRACTION MOTORS
von: Ustenko, A. V., et al.
Veröffentlicht: (2013)

STATISTICAL OPTIMIZATION OF FREQUENCY REGULATED INDUCTION ELECTRIC DRIVES WITH SCALAR CONTROL
von: Shurub, Yu. V.
Veröffentlicht: (2017)

PECULIARITIES OF DYNAMICS OF A FAST-DRIVEN INDUCTION-DYNAMIC DRIVE WITH A BISTABLE LATCH OF CONTACTS POSITION OF A CIRCUIT BREAKER BASED ON PERMANENT MAGNETS
von: Baida, E. I., et al.
Veröffentlicht: (2020)

CALCULATION AND DESIGN OF A ROBUST SPEED CONTROLLER OF A FREQUENCY-CONTROLLED INDUCTION ELECTRIC DRIVE
von: Khlopenko, N. J.
Veröffentlicht: (2020)

Improved speed sensorless control for induction motor drives using rotor flux angle estimation
von: Tran, C. D., et al.
Veröffentlicht: (2025)

SIMULATION OF AN AC DRIVE SYSTEM COMPRISING A CASCADE MULTILEVEL VOLTAGE INVERTER
von: Zhemerov, George G., et al.
Veröffentlicht: (2013)

STRUCTURAL SYNTHESIS OF A STABILIZING ROBUST CONTROLLER OF THE ROTOR FLUX LINKAGE
von: Khlopenko, N. J., et al.
Veröffentlicht: (2017)

Estimation of the main dimensions of the traction permanent magnet-assisted synchronous reluctance motor
von: Liubarskyi, B. G., et al.
Veröffentlicht: (2021)

MATHEMATICAL MODELLING OF TRANSIENTS IN THE ELECTRIC DRIVE OF THE SWITCH – THE MAIN EXECUTIVE ELEMENT OF RAILWAY AUTOMATION
von: Buriakovskyi, S. G., et al.
Veröffentlicht: (2020)

Synthesis of the digital regulator of the main contour of the three-circuit system of the linear electric drive of the working body of the mechanism of onboard aviation equipment
von: Denisov, Y. O., et al.
Veröffentlicht: (2021)

COMPARISON OF CONVERTER SYSTEMS FOR A HIGH-VOLTAGE VARIABLE-FREQUENCY AC DRIVE
von: Zhemerov, George G., et al.
Veröffentlicht: (2013)

ANALYSIS AND VERIFICATION OF THE OPERATION OF THE STABILIZING ROBUST CONTROLLER'S ELECTRICAL CIRCUIT OF THE ROTOR FLUX-LINKAGE CONTROL SYSTEM
von: Khlopenko, I. N., et al.
Veröffentlicht: (2020)

Development and study of a microprocessor automatic control system for a mono-switch tie type with a linear inductive electric motor and a discrete speed controller
von: Buriakovskyi, S. G., et al.
Veröffentlicht: (2022)

SIMULATION OF PARALLEL WORK OF ASYNCHRONOUS GENERATORS IN AUTONOMOUS INSTALLATION FOR CHARGING BATTERIES
von: Holovko, V., et al.
Veröffentlicht: (2018)

The impact of parasitic capacitances on the accuracy of scale transformation of high-voltage dividers
von: Haran, Y. O., et al.
Veröffentlicht: (2025)

Microprocessor control system of the electroontact surfacing with two roller electrodes
von: Чепель, Юлия Анатолиевна, et al.
Veröffentlicht: (2014)

Microprocessor control system of the electroontact surfacing with two roller electrodes
von: Чепель, Юлия Анатолиевна, et al.
Veröffentlicht: (2014)