FEATURES OF DESIGN THE PERMANENT MAGNET WINDGENERATOR OF HIGH POWER (600÷3600) kW

• Дата: 2020
• Автори: Permynov, Y., Monakhov, E., Volkov, L.
• Формат: Стаття
• Мова: Ukrainian
• Опубліковано: Institute of Renewable Energy National Academy of Sciences of Ukraine 2020
• Теми: gearless generators of modular design; winding options; tooth zone; meander winding; slot fill factor; the number of slots per pole and phase; the number of turns in the section; active length of conductors; electromagnetic power.; безредукторные генераторы модульной конструкции; варианты обмоток; зубцовая зона,
• Онлайн доступ: https://ve.org.ua/index.php/journal/article/view/255
• Назва журналу: Vidnovluvana energetika

The paper is based on the results of calculations of a number of synchronous gearless direct-drive wind generators of modular design [1] with permanent magnet excitation in range of power since 600 to 3600 kW at a wind speed that is taken abroad during the design – 12.5 m/s. This approach to the study of machines allows to evaluate the complex relationship of their parameters with a minimum of assumptions, in particular, to take into account the saturation of the most loaded sections of the magnetic circuit and determine the feasibility of using some possible winding options that provide the greatest electromagnetic power to the generators, taking into account the manufacturability of their implementation; the features of the change in the tooth zone of high-power machines are shown, due to the low rotation speed of the generators in gearless installations and justified for this reason, the possibility of using the "meander" winding. In such type of winding each phase is made in the form of a single continuous conductor, which eliminates the connection of sections in phase, which takes place in traditional windings, and reduces the resistance of the winding due to the absence of one frontal part in comparison with the coil section. When solving the manufacturing technology of such windings in the form of a copper bus, it is possible to increase the fill factor of the slots and the power of the generator in certain dimensions. It is possible to manufacture such a winding of cables, in this case the three-phase winding will represent three cables, which will simplify its manufacture, but the fill factor of the slots will be less. In the paper different options of meander windings are compared in order to simplify their manufacture and traditional loose windings with a different number of slots per pole and phase in order to increase the tooth pitch and simplify the manufacture of the stator core and winding.  Ref. 9, tabl. 1, fig. 5.